Bb1 wba 13 won’t get past errors

[Phan000]

I purchased a bb 1 goldfish game with a UBA installed. Machine works fine, no issues.

I put the UBA in a different machine, and have a WBA 13 with the enclosure.  Multiple errors after booting up.  Tried both jumper positions, tried with and without rs232, tried new transport (it is flashed correctly).

What is the correct jumper settings?

Any other ideas on what I can look at?


Thanks!

[Phan000]

Would a bad harness from the enclosure cause this?

Initially, the DBV would get power, but give jam and switch errors.

Now no power, just BV comm error or BV device error.

Really at a loss for what to try next.

[Phan000]

Got this sorted.  Transport was eprom based rather than flashed.