Ok, this will probably be a long post, so bare with me.
Short version....had a BB2E that worked great for years. One day both Monitors were dark. Troubleshoot it down to missing the 12vdc at the Junction Box behind the lower LCD on lefthand inside wall. Backplane power was normal at both Aux Plugs as the E Controller works. Just nothing at either plug in the top.
Without tearing into that J Box, I decided to just swap everything over into an extra near scrap level cabinet I had in storage.
Everything works as it should with the exception of the UBA Bill Validator and Printer. Game loads if I disable them both in the Set Up, but I have no way of adding Credits to play it.
So, I bought a TITO System to get me by until I could figure out the BV and Printer stuff.
I've set up everything correctly, but Legacy Bonusing will not work no matter how many times I set it up. Tried both Comm Ports, different TITO Boards, different Power Sources and so on. Nothing. So I still can't play the game.
Searched the forum and found a lot of posts about the Jumpers on the Backplane, all set correctly for the Validator and Comm for TITO. Even tried a different CPU-NTX2 and Backplane.
The Bill Validator hardware, Harness, Housing and UBA all came from the working machine, as did the Printer and Harness. (Working except for the Monitors)
I can get neither to work without errors. I recieve Stacker Missing, Bill Validator Jam and Stacker Switch Open. I'm sure there's not a secondary Harness that isn't connected or missing, nothing left like that in the old cabinet.
Same with Printer. Ready Light is on, but fails for Printer Comm Error.
The UBA continually cycles, so I sent it off for cleaning and ops checks. Came back as tested and working. Still has cycling non stop and BV Jam and Stacker Errors.
I bought a new one that was labeled as tested good. Same problem.
I'm about out of options here.
Anyone got any ideas that I haven't thought of yet?
There is only 1 Harness that plugs into the BV Housing. Am I missing something that is inside of the Housing that I can't see? Maybe a Stacker Switch?
I assumed that the Stacker, when inserted is sensed by the UBA.
Hope at least some of this made sense.
Thanks,
Curtis ash100